Home > Exhibition > Content

1000 w wind turbine starting torque is low

Mar 20, 2019

The starting torque of the 1000 w wind turbine is low. Because of the many factors affecting the starting torque of the motor, the cogging torque is also a very important factor. The motor of the 1000 w wind turbine adopts a 12-pole matching number of slots and uses a special magnetic circuit. The design effectively reduces cogging torque. At the same time, the starting torque is greatly reduced.

 

Moreover, the direct opposite of the chute in the 1000 w wind turbine and the magnet on the rotor is oblique, which reduces the attractive force between them, and the rotor does not work so hard, which reduces the torque of the rotor. Different levels of air gaps are different in size, which can effectively reduce the cogging. 1000 w wind turbines are molded by one die, the blades are balanced, and the balance rate is up to 99%.

 

The 1000 w wind turbine is lighter in weight because our stator uses a silicon steel sheet with low iron loss. Because the silicon steel sheet is very light, it also reduces the power loss of the generator at the same time; the tail is treated with ribs and has the function of resisting typhoon. The motor interface is also treated with ribs. High security performance. The 1000 w wind turbine uses a cast carbon brush with a life of 100,000 cycles, which effectively reduces the carbon brush contact resistance.www.titanwindturbine.com